Honda Accord

1998-1999 of release

Repair and car operation

Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
- Brake system
   System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement of brake shoes of disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Replacement of boots of drum-type brake mechanisms of back wheels
   Removal and installation of wheel cylinders
   Removal and installation of the main brake cylinder
   Check of a condition and replacement of brake lines and hoses
   Pumping of brake system
   Check of serviceability of functioning/tightness, removal and installation of assembly of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Cable replacement (ов) drive of the parking brake
   Check of serviceability of functioning, replacement and adjustment of the sensor switch of stoplights
   Check of serviceability of functioning and replacement of the sensor switch of level of brake liquid
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes

d42fda4b d42fda4b

Check of serviceability of functioning and replacement of the sensor switch of level of brake liquid



1. Disunite the electric socket of the sensor switch and uncover the GTTs tank.

2. Check freedom of a course of a float of the sensor. In case of identification of signs of jamming replace assembly. By means of an ohmmeter make sure of lack of conductivity between plugs of the socket of the sensor switch at the lifted float and in its existence at the lowered float.

3. Make sure available conductivity between socket plugs at the lowered float.

4. At negative results of checks replace the faulty sensor switch.



1. Disconnect from the sensor switch electroconducting.
2. Uncover the GTTs tank and replace it assembled with the sensor switch.
3. Installation is made upside-down.