Honda Accord

1998-1999 of release

Repair and car operation

Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
- Brake system
   System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
   Replacement of brake shoes of disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Condition check, removal and installation of a brake disk
   Replacement of boots of drum-type brake mechanisms of back wheels
   Removal and installation of wheel cylinders
   Removal and installation of the main brake cylinder
   Check of a condition and replacement of brake lines and hoses
   Pumping of brake system
   Check of serviceability of functioning/tightness, removal and installation of assembly of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Cable replacement (ов) drive of the parking brake
   Check of serviceability of functioning, replacement and adjustment of the sensor switch of stoplights
   Check of serviceability of functioning and replacement of the sensor switch of level of brake liquid
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes

d42fda4b d42fda4b

Check of serviceability of functioning, replacement and adjustment of the sensor switch of stoplights



1. Squeeze out a pedal of a foot brake and make sure of serviceability of operation of stoplights in assemblies of the back combined lamps.
2. If stoplights do not work, check a condition of the corresponding safety lock (see. Head Onboard electric equipment). Also check a condition of filaments of lamps of stoplights in both back combined lamps, and also lamps of a stoplight of the top level.

3. If lamps and a safety lock as it should be, find the sensor switch established in the top part of a pedal of a foot brake.

4. Disunite the electric socket of the sensor switch.
5. Check conductivity between socket plugs 2 and 3. At the squeezed-out pedal of a foot brake conductivity should take place, at the released - is not present.
6. Also check conductivity between plugs 1 and 4, - the return picture here should take place, i.e. at the squeezed-out pedal conductivity should be absent, and on the contrary.
7. At negative result of checks replace the sensor switch.



1. Disconnect from the sensor switch electroconducting.
2. Give a lock-nut on the party of the sensor switch turned to a pedal, then turn out the last from the basic arm.
3. Installation is made upside-down.



1. Release a lock-nut of the sensor switch and turn out the last so that its plunzher rested against a pedal of a foot brake.
2. Weaken a lock-nut of a pusher and, rotating the last flat-nose pliers, adjust properly height of provision of a pedal (see. Specifications).

Measurement should be made from an overlay of a pedal to the floor panel (not to a rug!).

3. Again strongly tighten a lock-nut.
4. Screw the sensor switch in an arm so that its plunzher appeared is completely drowned (a carving tip rests against an overlay of the lever of a pedal), then turn out it back on 1/2 turns and strongly tighten a lock-nut.
5. A hand squeeze out a pedal of a foot brake and measure size of its free wheeling. Compare result of measurement to requirements of Specifications. Make sure of serviceability of operation of stoplights when squeezing a brake pedal.