|
Honda Accord1998-1999 of releaseRepair and car operation |
|
Honda Chord + Honda Accord brand Cars + Settings and routine maintenance + Engine + Systems of cooling, heating - Power supply system and release Sbrasyvaniye of pressure in a power supply system Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel Check of a condition and replacement of fuel lines Removal and installation of the fuel pump Check of a condition and sensor replacement Removal and installation of a fuel tank Cleaning and repair of a fuel tank - general information Removal and installation of assembly of an air purifier Removal, installation and adjustment of a cable of an accelerator System of electronic injection of fuel (EFI) - the general information Check of serviceability of functioning of system of injection Removal and installation of the case of a throttle Removal and installation of a regulator of pressure of fuel Removal and installation of the fuel highway and fuel injectors Release system - the general information + engine Electric equipment + Engine management + gear shifting Box + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment + electric equipment Schemes |
Release system - the general information
The system of production of the fulfilled gases of all considered models consists of a final collector (ов), a reception pipe, the catalytic converter, the exhaust silencer, connecting tubular sections, fixing collars, and also basic arms and rubber loops by means of which final assembly is suspended to the car bottom. The wrong installation of components and sections of system leads to increase of level of noise and the vibrations transferred to a body of the car. Regularly examine all system on existence of traces of corrosion, deformations and mechanical damages. Check reliability of a tightening of fixture. Violation of tightness of components and their joints is fraught with hit of the fulfilled gases in car salon. Defective components and sections are subject to replacement. At strong damage of system by corrosion for undocking of its sections the gas cutting torch (it is alternatively possible to use a hacksaw on metal or a pneumatic chisel - do not forget to put on goggles and gloves) can be demanded.
d) Before installation grease a carving part of fixture with anti-taking hermetic; e) At installation of components watch, that between sections of system and nearby elements of a suspension bracket/body there was a sufficient gap. Special attention give to correctness of installation and reliability of fastening of the thermofilter of the catalytic converter. |
|