Honda Accord

1998-1999 of release

Repair and car operation

Honda Chord
+ Honda Accord brand Cars
+ Settings and routine maintenance
- Engine
   + Four-cylinder engines
   + V6 Engines
   - General and major maintenance of the engine
      Check of pressure of oil
      Check of kompressionny pressure in cylinders
      Diagnostics of a condition of the engine with use of the vacuum gage
      Removal of the power unit from the car - preparation and precautionary measures
      Removal and engine installation
      Alternative versions of schemes of regenerative repair of the engine
      Order of dismantling of the engine by its preparation for major maintenance
      Dismantling of a head of cylinders
      Cleaning and check of a condition of a head of cylinders
      Service of valves
      Assembly of a head of cylinders
      Removal and check of a condition of balancing shaft (4-cylinder engines)
      Removal of shatunno-piston assemblies
      Removal of a cranked shaft
      Cleaning of the block of the engine
      Check of a condition of the block of the engine
      Honingovaniye of mirrors of cylinders
      Check of a condition of components of shatunno-piston group
      Check of a condition of a cranked shaft
      Check of a condition and selection of loose leaves of radical and shatunny bearings of a cranked shaft
      Engine assembly order
      Installation of piston rings
      Installation of a cranked shaft and check of working gaps of radical bearings
      Installation of a back epiploon of a cranked shaft
      Installation of shatunno-piston assemblies and check of size of working gaps in shatunny bearings of a cranked shaft
      Installation of balancing shaft (four-cylinder engines)
      Trial start and engine running in after major maintenance
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Engine management
+ gear shifting Box
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ electric equipment Schemes

d42fda4b d42fda4b

Check of pressure of oil


1. Pressure drop of oil can be considered as a sign of that the engine needs regenerative repair. The control lamp of pressure of oil is not the instrument of diagnostics of system of greasing, and only informs the driver on dangerous decrease in oil pressure. Even the measuring instrument of pressure of oil built in the dashboard, despite a big detail of issued information, it is possible to consider only as the device of information character. For data acquisition about pressure of oil which then can be compared to requirements of Specifications, it is necessary to use mechanical (not the electric!) a manometer in a combination to an exact tachometer.
2. Find the block of the sensor switch of pressure of oil.

3. Remove the sensor switch and establish instead of it a transitional nozzle for connection of a mechanical manometer. For sealing of carving connection of a nozzle use a sealing tape from teflon, or a tape FUM.
4. According to instructions of manufacturers connect to the engine an exact tachometer.
5. Check pressure of oil at working on the turns stipulated in Specifications and the heated-up engine to normal working temperature. Compare results of measurements to standard data. At excessively low pressure of oil it is necessary to estimate degree of wear of bearings and the oil pump.